Not much to show this week but progressing still. I’ve started closing up the bulkhead and B pillar on the N/S, working my way down the area.
I’ve only repaired the bits that sit above the wheel tub and then a small bit beneath it thus far:
The cab floor repair pieces arrived this week so I decided to get some zinc primer on the underside/inside of all the little bits that are sitting around the workshop at the minute (I’ll epoxy them at the weekend and then hopefully finish the bulkhead and wheel tub repairs):
Cab floors:
Cab floor middle piece, outer rear valance and outer sliding door repair:
Bulkhead bulge piece (only the ends properly painted as I won’t need the centre), closing panels for the front arches, seatbelt mounts and repair for the O/S bulkhead.
