Keeping up the momentum. Cab door inner bottoms into Neptune blue. Glad I stuck with the original colour. Four days off now to paint everything else. See you on the other side
Door inners into pastel white tonight! Pretty sure the inners now look better than the outers did before I started.
And started wet sanding the rear of the van down.
O/S rear quarter and front arch rubbed back tonight with 400, and made a good start on the roof.
Just an hour or so tonight, but got two big panels rubbed down with 400 grit.
Long panels on the van re-primed (much happier with the arch profile on the N/S now). And started the final rub down.
Doors all re-primed tonight following the further filler work they needed.
Another long weekend spend sanding sodding filler again! I’ve had to correct some minor imperfections on both cab doors, the rear hatch, the sliding door, the large side panel and both rear arches (so basically the whole van!).
I’ve got some further work on the O/S rear arch to do tomorrow night then I’ll re-prime it all later in the week. I’ve got a day booked off either side of the last weekend of this month which is my target date for getting everything painted. If I’ve not got the filler and primer work perfect this time it’ll have to do as realistically I reckon that weekend will be my last chance to paint before it starts getting too cold. I’d rather have the van ready for next spring and have a few minor paint blemishes than spend another summer with the van stuck indoors!
Both cab doors and the sliding door rubbed down with 240 grit tonight.
The O/S cab door needs a dab more filler in one spot, the N/S rubbed down ok but is a little thin in areas where I’ve rubbed down to the epoxy so I’ll re-prime both doors.
The sliding door doesn’t look so great, I’m not sure why I primed it as it needs further filler work in a lot of areas. I’ll re-fill and re-prime this too.
Tomorrow’s job will be to rub down the roof and the remaining rear quarter and then that’s everything initially rubbed back. Slowly Slowly.
The paint prep continues! I’ve been making my way round the van with 240 grit to see where we’re at.
Rear corners and rear end are fine bar a small area to the right of the N/S light aperture which needs some fine filler to bring the level up a bit:
Front end, front arches and B pillar are good to go over again with 400 grit as they look bob on (apologies for the back lit pic):
The large side panel has some lows which need further filler work and a re-prime but it’s not far off at all (the epoxy primer under the high build is a slightly different colour which makes it easy to know when to stop):
Similarly the N/S rear quarter has some lows that need filler and a reprime but isn’t far off. I’ve been using Proworx Silk as my fine filler. Lots of people rave about Dolphin glaze, but I’ve found it a nightmare to work with as it doesn’t sand very well, the silk stuff still goes on very smoothly but sands sooo much nicer.
Cab doors and sliding door tonight!
